Field of Application

outstanding fast cloning and testing tool
easily to use with touchscreen, even from non technicians
stand alone unit - no host PC needed
clone drives even with defect sectors (as long as a drive is accessible)
supports 1x SATA (also SSD) source drive
supports 1 x SATA (also SSD) target drive
create a 100% 1:1 clone with one cloning operation (multi pass)
supports (tested) SATA adapters for modern storage (SSD), i.e. mSATA,
SD Card, M.2 NGFF, MacBook, Zenbook, Lenovo Carbon Ultrabook etc.
supports several test operations, drive wiping etc.

write protection for the source drive (software)
hash calculation for source drive + target drive while cloning
possible standards: MD5, SHA1, SHA224, SHA256, SHA384, SHA512

clone drives if still accessible
if a clone doesn’t show partitions and/or data, use a data recovery software
to surch and retrieve files + folders.

create a clone of all original raid drives
mark the original drives + the corresponding clones with the position number
where inserted in the raid hardware
if the original raid hardware is working properly, replace all original drives with
a corresponding clone and then try to rebuild the raid with the on board solution
(if exist) of the raid hardware.
if that doesn’t work, connect the clones in its correct order to a PC and try to
retrieve the data with a special raid data recovery software.

all above points for Data- and Raid Recovery + Forensics
plus repair of defect Windows systems caused from defect drives:
create two 1:1 clones of the defect drive (if original is defect clone the 1st clone)
use one new clone drive to replace the old defect drive and start the computer.
If that doesn’t work, try to start the laptop manufacturers Windows recovery,
otherwise install an OEM Windows (corresponding to the license type) + drivers.
Finally copy the customers data from a 2nd clone to the recovered Windows system.
If the clone doesn’t show partitions or data, you need to use a data recovery software
to surch and retrieve the customers data.